Heat Pump Repair in McKinney, TX
Heat Pump Repair for homes and businesses in McKinney and the surrounding Collin County area.
Heat Pump Repair across McKinney
From historic downtown homes with tricky ductwork to Craig Ranch new builds — we work on all of it.
McKinney is about thirteen miles from us, straight across on US-380. We are usually there inside the hour on an emergency call.
McKinney spans a wider range of housing than anywhere else we cover — century-old homes around the downtown square with retrofitted ductwork, and Craig Ranch and Trinity Falls builds barely out of warranty. The two need very different approaches.
We work throughout McKinney, including Stonebridge Ranch, Craig Ranch, Adriatica, Historic Downtown, Trinity Falls, Tucker Hill.
Symptoms we see most
Lukewarm air in heating mode, ice that never clears from the outdoor coil, a system stuck in emergency heat, a reversing valve that will not shift between heating and cooling, short cycling, or an electric bill that doubled overnight because the auxiliary strips are running constantly.
What heat pump repair covers
- Defrost board, sensor and control diagnosis
- Reversing valve and solenoid repair or replacement
- Refrigerant leak search and correct charge in both modes
- Auxiliary and emergency heat strip and sequencer repair
- Compressor, contactor and capacitor service
- Outdoor fan motor replacement
- Dual-fuel changeover and staging setup
Full detail on our heat pump repair page — what we check, how we price it and the questions we get asked most.
Heat Pump Repair in McKinney — common questions
How quickly can you reach McKinney?
McKinney is about thirteen miles from us, straight across on US-380. We are usually there inside the hour on an emergency call. Call 469-919-7646 and we will give you an arrival window before you hang up.
Why is ice building up on my heat pump in winter?
A light frost that clears during the defrost cycle is normal. Solid ice that never melts means the defrost cycle is not running — usually a failed defrost board or sensor, or a reversing valve that will not shift. Do not chip the ice off; call us before the coil is damaged.
Why is my heat pump blowing cool air on heat mode?
Heat pump supply air is naturally cooler than gas furnace air — around 90–100°F rather than 130°. That feels lukewarm but is normal. If it is genuinely cold, the reversing valve, charge or defrost control is the likely fault.
Common heat pump repair problems in McKinney
Some of these you can check yourself in ten minutes. We would rather you found it than paid us to.
Need it fixed today?
Same-day service across Celina, Prosper, Frisco, McKinney and Plano — and a real person on the emergency line 24/7. Tell us what your system is doing and we will give you a straight answer.
