Furnace Repair in Celina & Collin County, TX
A furnace that will not light is a comfort problem. A furnace with a cracked heat exchanger is a safety problem. We treat every heating call as both — diagnosing the fault and testing combustion and carbon monoxide before we call it fixed.
Common North Texas furnace failures
Around here furnaces sit idle for eight months and then get asked to run flat out on the first cold night. The usual suspects: a dirty flame sensor that shuts the burner down after a few seconds, a failed hot-surface igniter, a pressure switch stuck open from a blocked flue or condensate trap, a bad inducer motor, a control-board lockout, or a limit switch tripping from restricted airflow.
Safety comes first, every time
Every furnace repair includes a combustion analysis, a heat-exchanger inspection, a flue and venting check, a gas-pressure verification and an ambient carbon monoxide reading. If we find a cracked heat exchanger or an unsafe vent, we will show you the evidence and red-tag the appliance — we will not leave a CO risk running in your house.
Heat pump homes too
Many newer homes in Celina, Prosper and Frisco run heat pumps with electric auxiliary heat instead of gas. If your electric bill spiked and the air from the vents feels lukewarm, the system is likely stuck on emergency heat because of a defrost-board, reversing-valve or refrigerant fault. We diagnose those the same day.
Book furnace repair
Same-day appointments across Celina, Prosper, Frisco, McKinney and Plano. Emergency line answered 24/7.
- HoursMon–Sat 8:00 AM – 5:00 PM · 24/7 emergency service
- LicenseTACLA128438C
Furnace Repair — what we handle
- Igniter, flame sensor and thermocouple replacement
- Inducer motor, pressure switch and limit switch repair
- Control-board and transformer diagnosis
- Blower motor and capacitor replacement
- Gas valve and burner service and adjustment
- Heat-exchanger inspection and carbon-monoxide testing
- Flue and venting inspection
- Condensate trap and drain clearing on 90%+ furnaces
Furnace Repair — questions we get asked
Why does my furnace turn on then shut off after a few seconds?
Classic short cycling on ignition — nearly always a dirty flame sensor that cannot prove the flame, or a cracked/failing igniter. Both are inexpensive parts and quick fixes. If it is instead running long and tripping a limit, the cause is usually restricted airflow from a dirty filter or closed vents.
Is a cracked heat exchanger really dangerous?
Yes. A cracked heat exchanger can let combustion gases including carbon monoxide into the air you breathe. It is not repairable — the exchanger or the furnace has to be replaced. We verify with a visual inspection and a combustion analyzer before making that call, and we show you what we found.
My furnace smells like burning dust on the first cold day — is that normal?
Usually yes. Dust that settled on the heat exchanger over the summer burns off in the first cycle or two. If the smell is electrical, acrid, or lasts longer than an hour of runtime, shut the system off and call us.
How fast can you get out for no heat?
No-heat calls are priority-dispatched, and our line is answered 24/7 through the winter. Most North Dallas no-heat calls are seen the same day.
Common furnace repair problems, explained
Some of these you can check yourself in ten minutes. We would rather you found it than paid us to.
You might also need
Furnace Installation
Replacing a furnace is a fifteen-to-twenty-year decision. We help you choose the right efficiency and stage for how your house actually behaves, then…
Explore furnace installation
Furnace Tune-Up
The cheapest furnace repair is the one you never need. A fall tune-up catches the weak igniter, the dirty flame sensor and the marginal inducer motor…
Explore furnace tune-up
Heat Pump Repair
Heat pumps run twelve months a year, which means twice the runtime and twice the wear of a gas system. They also fail in ways a furnace never does —…
Explore heat pump repair
Emergency AC Repair
Air conditioners do not fail politely at 10 a.m. on a Tuesday. When yours quits on a 100° Saturday night, with a newborn, an elderly parent or a…
Explore emergency ac repairFurnace Repair available in Celina, Prosper, Frisco, McKinney, Plano, Allen, Little Elm, The Colony, Lucas, Murphy, Gunter, Pilot Point, Van Alstyne, Melissa, Anna, Aubrey and every city we serve.
Need furnace repair?
Same-day service across Celina, Prosper, Frisco, McKinney and Plano — and a real person on the emergency line 24/7. Tell us what your system is doing and we will give you a straight answer.
