Licensed & insured · TACLA128438C Mon–Sat 8:00 AM – 5:00 PM · 24/7 emergency service Celina, TX & North Dallas
support@pandaheating.com

Heat Pump Repair in Prosper, TX

Heat Pump Repair for homes and businesses in Prosper and the surrounding Collin County area.

Collin County · ZIP 75078

Heat Pump Repair across Prosper

Minutes from our shop. We handle a lot of new-construction warranty follow-up and builder-grade system upgrades in Prosper.

Prosper is six miles from our Celina base — closer than most Prosper callers expect. A morning call is a same-day visit here, not a next-day one.

Prosper has grown fast enough that a large share of its housing stock is under ten years old, which means builder-grade equipment coming out of warranty at roughly the same time across whole subdivisions.

We work throughout Prosper, including Windsong Ranch, Star Trail, Lakewood, Whitley Place, Prosper Trail, Ladera.

Symptoms we see most

Lukewarm air in heating mode, ice that never clears from the outdoor coil, a system stuck in emergency heat, a reversing valve that will not shift between heating and cooling, short cycling, or an electric bill that doubled overnight because the auxiliary strips are running constantly.

What heat pump repair covers

  • Defrost board, sensor and control diagnosis
  • Reversing valve and solenoid repair or replacement
  • Refrigerant leak search and correct charge in both modes
  • Auxiliary and emergency heat strip and sequencer repair
  • Compressor, contactor and capacitor service
  • Outdoor fan motor replacement
  • Dual-fuel changeover and staging setup

Full detail on our heat pump repair page — what we check, how we price it and the questions we get asked most.

Answers

Heat Pump Repair in Prosper — common questions

How quickly can you reach Prosper?

Prosper is six miles from our Celina base — closer than most Prosper callers expect. A morning call is a same-day visit here, not a next-day one. Call 469-919-7646 and we will give you an arrival window before you hang up.

Why is ice building up on my heat pump in winter?

A light frost that clears during the defrost cycle is normal. Solid ice that never melts means the defrost cycle is not running — usually a failed defrost board or sensor, or a reversing valve that will not shift. Do not chip the ice off; call us before the coil is damaged.

Why is my heat pump blowing cool air on heat mode?

Heat pump supply air is naturally cooler than gas furnace air — around 90–100°F rather than 130°. That feels lukewarm but is normal. If it is genuinely cold, the reversing valve, charge or defrost control is the likely fault.

Need it fixed today?

Same-day service across Celina, Prosper, Frisco, McKinney and Plano — and a real person on the emergency line 24/7. Tell us what your system is doing and we will give you a straight answer.